DIY Azeron
Created on 2023-01-10T18:53:58-06:00
STL files were for-pay and appear to have been killed (probably DMCA'd.)
Bill of Materials
- 3d Printer
- STL files to print ($13)
- 3/8in silicone pads 100/$10 10c each project requires 10
- 12 micro switches $10/25 switches
- Micro controller. $7 each ( you need 1) $21
- M3 screws and nuts $9 (you will use about 1/3 of them
- Analog dpad $2 5/$10
- 22awg wire, I stripped from old cat 5/6 cable (ethernet) about 12ft
- Soldering station/flux/solder
- Micro Usb cable
Microcontroller notes
Azeron officially used the Teensy 2.0++ until they were no longer available. The clone in this instructable uses a "KeeYees Pro Micro ATmega32U4 5V 16MHz Micro USB" a.k.a. a generic Arduino Leonardo clone.